
Should you repair or replace a washing machine that has broken down?
A plain way to decide between repairing and replacing a broken washer, with typical repair costs in Metro Vancouver and what to check before you spend anything.
Key takeaways
- Most Metro Vancouver washer repairs run $180–$420 all-in, depending on the part.
- Repair makes sense when one part has failed and the rest of the machine is sound.
- Replace when the quote nears the cost of a comparable new machine.
- Rust, repeat breakdowns and drum or bearing damage point toward replacing.
- Renters and condo owners should check with the landlord or strata first.
A washer that quits mid-cycle leaves you with a wet load and a decision. You can repair it or buy a new one. The right answer depends on what failed, how the machine has behaved so far, and what the quote says.
This guide walks through how to decide. It is useful whether or not you ever call us.
What a washer repair usually costs
Most washing machine repairs in Metro Vancouver run $180–$420 all-in. The spread comes down to the part. A drain pump, a water inlet valve or a door lock sits at one end. A larger part sits at the other.
A good technician gives you the number before any work starts. Ours quotes on-site, upfront, before we touch anything. If you are comparing quotes from other companies, ask whether the price includes the part, the labour and the visit.
When repairing makes sense
Repair is usually the better choice when the failure is clear and limited. Here are the common signs.
- One symptom points to one part. The washer will not drain, will not fill, or shows a single error code.
- The rest of the machine works well. The drum spins smoothly, the door seals, and the cabinet is clean inside and out.
- The machine has not broken down repeatedly. One failure after steady use is a normal wear event.
- The repair costs well under the price of a comparable new machine.
Problems like a washer that will not drain or spin, fills slowly, or will not start often come down to a single part. Those are the repairs that tend to land in the lower and middle part of the price range.
When replacing makes sense
Some problems make a repair poor value, even if it is possible. Think about replacing when you see these.
- The quote is close to the price of a comparable new machine.
- The drum, bearings or tub have failed. These usually show up as loud grinding, heavy banging on spin, or a drum that wobbles when you move it by hand.
- There is rust on the base or lower cabinet. That points to leaking over a long time, and other parts may follow.
- The washer has needed several repairs in a short stretch.
- The machine no longer fits how you live. A bigger household may want a larger drum.
A rule many people use is to avoid putting more than about half the cost of a new machine into a repair. Treat that as a rough guide, not a fixed line. A newer, well-kept machine is worth more repair money than an old one.
Things that apply to Burnaby homes
Burnaby has a wide mix of housing, and that changes the decision.
In the tower clusters around Metrotown, Brentwood and Lougheed, many washers are stacked or built into a closet. Before you buy a replacement, measure the space, the door swing and the hallway. A repair avoids all of that. If you rent, check with your landlord first, because the machine may be theirs and the repair may be their cost. Condo owners should also check strata rules before bringing in a new unit.
In the older post-war bungalows and split-levels in Burnaby Heights, Capitol Hill and South Slope, the washer often sits in a basement or utility room. Look at the floor and the base of the machine. Rainfall rises with elevation, so Capitol Hill and Burnaby Mountain stay wetter and cooler, and a damp laundry room can hide a slow leak. Rust or stains under the washer are worth noticing.
Townhouse complexes, which fill much of the middle of the city, usually have laundry in a tight corner or closet. As with the towers, a repair spares you from fitting a new machine into a small space.
Checks to do before you decide
A few minutes of checking can save you a service call or a purchase.
- Check that the machine has power and the cord is firmly in the outlet.
- Look at the drain hose for kinks and make sure the drain filter, if your model has one, is clear.
- Note any error code and write down when the problem started.
- Run an empty cycle and listen for grinding, banging or squealing.
- Look under and behind the machine for water, rust or damp patches.
- Find the model and serial number on the label so you can compare a quote with a new machine.
If the machine passes these checks and still fails, the cause is likely a part that needs replacing. That is a repair question, not a sign the whole washer is finished.
Questions to ask about any quote
A quote should help you decide, so ask for details.
- What exactly has failed, and how did you confirm it?
- Is the price all-in, including the part and the labour?
- Is there a warranty on the part and on the work?
- Do I pay if the repair does not fix the problem?
Our answers are simple. You get an upfront quote on-site before work begins. You do not pay unless we fix it, though a service call fee applies. Every job carries our Fixed Right Promise, which is a 90-day parts warranty and a 7-day satisfaction guarantee.
When to call a professional
Call a technician if the washer leaks, trips a breaker, smells of burning, or shows the same error after you have checked the basics. These are not good jobs to guess at. A technician can tell you which part failed and what it will cost. You can then compare that number with a new machine and make the call. If the quote says replace, a straight answer is still useful to you.
Need a hand from a real technician?
Our licensed pros repair washers and dryers across Metro Vancouver — same-day and next-day, with 90-day parts warranty + 7-day satisfaction guarantee.
Keep reading
What does agitator maintenance involve on a top-load washing machine?
Agitator maintenance is a short check you can do at home. Clean it, test that it sits tight, and listen for clicking. Here is what to look at and when a repair makes sense.
How much does it cost to fix a Samsung washer?
Most washer repairs in Metro Vancouver run $180 to $420 all-in, and a Samsung is no different. Here is what moves the price and how to get a fair quote.